Pneumatic conveying equipment consists of four major components: 1: Air Part 2: The material sealed pump 3: Falling ash hopper and tube 4: Ash pipes. Which material sealed pump and ash bucket manufacturer responsible. The rest by the user with. Material sealed pump from the inlet section, diffusion mixing chamber, the material components. Intake in part by the intake valve, activities duct, adjusting mechanism, nozzles and other components. Diffusion mixing chamber by the pump, the gasification unit, composed of the tribe hopper, discharging part by the diffuser (tapered tube, diverging tube) ash short sections. Pneumatic conveying equipment works: from the gas source to the low-pressure air, the control valve (or valves) butterfly valve, activities duct, diffuser nozzle into the pump chamber, when powdered or granular material from the hopper down down into the nozzle and the diffuser airflow between the high zone, i.e. blown. Coupled with the bottom of the gasification gasification plant, so that the material vaporized from a suspended state. After incurs high velocity air diffuser into a tapered tube, through the diffuser throat, into the feed conduit, a discharge to the desired point, the completion of the feeding process. Pneumatic conveying equipment installation: 1, under normal circumstances, material sealed pump mounted on the end of more appropriate materials warehouse, blanking smoothly. If you end up not in the library, can be placed next to. However, the drop tube angle ≥ 45 °. If installed in the lower part of the ESP ash bucket, a pump can be a struggle, but also two bucket two inclined tube a pump; special circumstances may also four bucket four helical tube is inserted into a pump seal, but it's all falling ash chute slope should be ≥ 45 °. 2, material sealed pump is generally placed on a hard level surface without the need of laying the foundation anchor bolts installed, when the wind pipe, outlet tube connected to a good future, can be put into operation. But requires inlet pipe and tubing connection should install a flexible section header. 3, the total height of the pump seal material (including material sealed pump hopper) is generally 3.5-4.5m, according to the actual situation can be appropriately changed. 4, material sealed pump placed export orientation, according to the site conditions, generally over the location of the ash silo direction is appropriate, or may be based on the trend line. 5, the top of the device requires libraries scattered gas precipitator material sealed pumping volume should be greater than the total amount expected with the wind. Do not allow positive pressure in the case library, so as not to affect the conveying system work. 6, requiring gas source material sealed pump, ash pipe system-sealed, air leakage rate of less than 0.2%. Pneumatic conveying equipment transmission efficiency, the overall device structure is relatively simple, easy maintenance, easy to automate, and is conducive to environmental protection. Especially for factory floor internal transport, the transport process and can be combined with the production process, which helps to simplify the process equipment. To do this, you can greatly improve labor productivity, reduce costs and floor space. Material sealed pumps, wet mixer, pneumatic conveying equipment, silo top filter, 508 release valve, bulk machine http://www.zzgaotie.com